Article Number (Market Facing Number) |
6ES7307-1EA01-0AA0 |
Product Description |
SIMATIC S7-300 Regulated power supply PS307 input: 120/230 V AC, output: 24 V/5 A DC |
Product family |
1-phase, 24 V DC (for S7-300 and ET200M) |
Product Lifecycle (PLM) |
PM300:Active Product |
Technical data
Input |
|
Input Note |
phase AC Automatic range selection |
Supply voltage 1 at AC Rated value 2 at AC Rated value |
120 V 230 V |
Input voltage 1 at AC 2 at AC |
85……132 V 170……264 V |
Wide-range input |
No |
Overvoltage resistance |
2.3 × Vin rated, 1.3 ms |
Mains buffering |
at Vin = 93/187 V |
Mains buffering at Iout rated, min. |
20 ms; at Vin = 93/187 V |
Rated line frequency 1 |
50 Hz |
Rated line frequency 2 |
60 Hz |
Rated line range |
47……63 Hz |
Input current at rated input voltage 120 V at rated input voltage 230 V |
2.3 A 1.2 A |
Switch-on current limiting (+25 °C), max. |
20 A |
Duration of inrush current limiting at 25 °C maximum |
3 ms |
I²t, max. |
1.2 A²·s |
Built-in incoming fuse |
T 3,15 A/250 V (not accessible) |
Protection in the mains power input (IEC 898) |
Recommended miniature circuit breaker: from 6 A characteristic C |
Output |
|
Output |
Controlled, isolated DC voltage |
Rated voltage Vout DC |
24 V |
Total tolerance, static ± |
3 % |
Static mains compensation, approx. |
0.1 % |
Static load balancing, approx. |
0.5 % |
Residual ripple peak-peak, max. |
50 mV |
Residual ripple peak-peak, typ. |
10 mV |
Spikes peak-peak, max. (bandwidth: 20 MHz) |
150 mV |
Spikes peak-peak, typ. (bandwidth: 20 MHz) |
20 mV |
Product function Output voltage adjustable |
No |
Output voltage setting |
- |
Status display |
Green LED for 24 V OK |
On/off behavior |
No overshoot of Vout (soft start) |
Startup delay, max. |
2 s |
Voltage rise, typ. |
10 ms |
Rated current value Iout rated |
5 A |
Current range |
0 ... 5 A |
Supplied active power typical |
120 W |
Short-term overload current on short-circuiting during the start-up typical at short-circuit during operation typical |
20 A 20 A |
Duration of overloading capability for excess current on short-circuiting during the start-up at short-circuit during operation |
100 ms 100 ms |
Parallel switching for enhanced performance |
Yes |
Efficiency |
|
Efficiency at Vout rated, Iout rated, approx. |
87 % |
Power loss at Vout rated, Iout rated, approx. |
18 W |
Closed-loop control |
|
Dynamic mains compensation (Vin rated ±15 %), max. |
0.1 % |
Dynamic load smoothing (Iout: 50/100/50 %), Uout ± typ. |
1 % |
Load step setting time 50 to 100%, typ. |
0.3 ms |
Load step setting time 100 to 50%, typ. |
0.3 ms |
Protection and monitoring |
|
Output overvoltage protection |
Additional control loop, shutdown at < 28.8 V, automatic restart |
Current limitation |
5.5 ... 6.5 A |
Property of the output Short-circuit proof |
Yes |
Short-circuit protection |
Electronic shutdown, automatic restart |
Enduring short circuit current RMS value maximum |
7 A |
Safety |
|
Primary/secondary isolation |
Yes |
Galvanic isolation |
Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 |
Protection class |
Class I |
Leakage current maximum typical |
3.5 mA 0.5 mA |
Degree of protection (EN 60529) |
IP20 |
Approvals |
|
CE mark |
Yes |
UL/cUL (CSA) approval |
cULus-Listed (UL 508, CSA C22.2 No. 142), File E143289 |
Explosion protection |
ATEX (EX) II 3G Ex nA II T4; cULus (ANSI/ISA 12.12.01, CSA C22.2 No.213) Class I, Div. 2, Group ABCD, T4, File E330455 |
FM approval |
Class I, Div. 2, Group ABCD, T4 |
CB approval |
No |
Marine approval |
In S7-300 system |
EMC |
|
Emitted interference |
EN 55022 Class B |
Supply harmonics limitation |
EN 61000-3-2 |
Noise immunity |
EN 61000-6-2 |
Environmental conditions |
|
Ambient temperature during operation — Note during transport during storage |
0 ... 60 °C with natural convection -40 ... +85 °C -40 ... +85 °C |
Humidity class according to EN 60721 |
Climate class 3K3, 5 … 95% no condensation |
Mechanics |
|
Connection technology |
screw-type terminals |
Connections Supply input Output Auxiliary |
L, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm² single-core/finely stranded L+, M: 3 screw terminals each for 0.5 ... 2.5 mm² - |
Width of the enclosure |
60 mm |
Height of the enclosure |
125 mm |
Depth of the enclosure |
120 mm |
Required spacing top bottom left right |
40 mm 40 mm 0 mm 0 mm |
Weight, approx. |
0.6 kg |
Product feature of the enclosure housing for side-by-side mounting |
Yes |
Installation |
Can be mounted onto S7 rail |
Mechanical accessories |
Mounting adapter for standard mounting rail (6EP1971-1BA00) |
MTBF at 40 °C |
2 480 589 h |
Other information |
Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified) |
http://www.plcchinasupplier.com/